More power!

Its been a long time since an update, but we moved house at the start of the year and things have been hectic. At least, thats my excuse and I’m sticking to it! I have been making progress with R2 in the last couple of months, doing a lot of work on his brain for starters, and painting various parts.

Code wise, there has been a couple of fairly drastic rewrites since my last update. The interface is a REST API, which sends commands to various modules as before. I’ve added a scripting module now, so that scripts or loops can be initiated such as random sounds, or a dance routine. The servo module had to have a major rewrite too as I discovered that I could only control one servo at once and had to wait for that to finish before another command could be sent. That wasn’t much good! I’ve also written the first of the actual controller interfaces (not counting a simple web one for testing), R2 can now be controlled from a PS3 controller. Button combos are read in from a csv file to trigger certain effects or scripts. Lastly, R2 now has a voice, and can play any mp3 stored in a directory, including selecting random ones from a list of types. Next step is to get either the Pi or the A la mode Arduino to control the speed controllers. I don’t want to run them off the Adafruit i2c servo controller for safety, I’d rather drive them directly and have some form of watchdog to make sure R2 doesn’t go on a rampage. All the code is still available on GitHub under my user, dpoulson

The PDU also needed a rethink, not least of all because of the amount of current it needed. The setup now has feeds directly to the speed controllers, with relays on the output from them to the motors so I can break the circuit if needs be. These relays will automatically turn off if the battery is disconnected so that any pushing of R2 will not feedback into the speed controllers and fry them. The relays will also be controlled from GPIO pins on the Raspberry Pi so I can disconnect them via an API call. I’ll also have an input for a kill switch that will have to be permanently on if any of the motors are to be powered, possibly using a transmitter in a replica droid caller or hilt of a light saber. I’ve a base idea for the new relay controls:

 The relays I’ve found are Omron G4A-1EA, which have the benefit of the switched load being on spade connectors on the top, rather than through PCB traces, which when I did the calculations would need to be massive to support the potential current running through them. This allows me to make a simple PCB with the controller circuit, and hook the 24V battery up to it to power the coils. If the battery is removed, the coils turn off and the circuits are broken. No fried speed controllers.

The 24V connection will probably go through the fuse box I’ve installed, with a hefty fuse. The makers of the speed controllers don’t actually recommend a fuse but I’ve seen a few comments saying a 60+A fuse can’t be a bad idea, just in case!

The battery will connect directly to the center contacts of a DPDT switch, with the fuse box on one side, and the charger connection on the other. This will allow charging the batteries without taking them out of the droid. Not sure if this is best practice or not, needs more research. Currently they are just a pair of 12V SLA batteries that I had, connected in series to give the full 24V.

I’m hoping to get some time either this weekend or next, to hook up the motors, speed controllers, and battery, to test them out and get an idea of potential current draw. They’ll be controlled with a standard RC transmitter/receiver for now. If I can get the legs onto R2 he may even be drivable by xmas.

Fingers crossed!